|
Technology
|
|
|
Standard
|
IEEE 802.3 for 10BaseT,
IEEE 802.3u for 10/100Base-TX,
IEEE 802.3ab for 1000BaseT
IEEE 802.11n/g Wireless LAN
IEEE 802.11ac Wave 1 Wireless LAN
IEEE 802.11i Wireless Security
Highest Data Rate:
2.4G IEEE 802.11n: 300Mbps @ 40MHz
5G IEEE 802.11ac: 866Mbps @ 80MHz
|
|
Interface
|
|
|
Ethernet Port
|
1x 10/100/1000Base-T(X) WAN
1x 10/100/1000Base-T(X) LAN
M12 X-code Connector
|
|
WIFI
|
IEEE802.11n 2.4G Band, 2T2R MIMO IEEE802.11ac 5G Band, 2T2R MIMO
|
|
USB + Console
|
USB + RS-232 Diagnostic Console, M12 A-code Connector
|
|
Power Input
|
2x 24VDC (±15%) Power Input, M12 A-code Connector
*2x 110V(±15%) by option
|
|
WIFI
|
|
|
Chipset
|
Qualcomm Atheros Processor and 802.11ac WIFI Chipset
|
|
Capability
|
5G IEEE 802.11ac Wave 1 + 2.4G IEEE 802.11n
5G: IEEE 802.11ac 2T2R MIMO, up to 866Mbps PHY Rate, 20-/40-/80-MHz Channels 2.4G: IEEE 802.11n 2T2R MIMO, up to 300Mbps PHY Rate, 20-/40-/80-MHz Channels Dual Radio Concurrent Design, up to 1.16Gbps PHY Rate
|
|
MIMO
|
5G: IEEE 801.11ac 2T2R MIMO
2.4G: IEEE 801.11n 2T2R MIMO
|
|
RF Modulation
|
802.11ac, 802.11g/n: OFDM (BPSK,QPSK,16-QAM,64QAM; 256QAM@11ac)
|
|
Operating Frequency
|
5GHz Typical Band: (802.11ac WIFI)
CE: 5.170~5.250GHz, 5.500~5.700GHz, Support Dynamic Frequency Selection (DFS)
FCC: 5.170~5.250GHz, 5.740~5.825GHz
(Programmable for other 5G Band)
2.4GHz Band: (802.11n WIFI)
2.412~2.472GHz
(Programmable for different country regulations)
|
|
RF Output Power
|
5.8GHz Band:
27dB EIRP for ETSI 301 893 (Band 3)
Certificated for use with up to 10dBi anntenna gain
2.4GHz Band:
20dB EIRP for CE (ETSI 300 328)
Certificated for use with up to 9dBi anntenna gain
(Controllable for different country regulations, check user manual for detail)
|
|
RF Sensitivity
(1st Radio, 2.4G Band)
|
802.11b: -86dBm@11M 1Rx
802.11g: -85dBm@6M 1Rx, -72dBm@54M 1Rx
(Added 3dBm@2Rx in average, ±2 dBm tolerance)
|
|
RF Sensitivity
(2nd Radio, 5G Band)
|
802.11a: -75dBm@54M 1Rx, -86dBm@6M 1Rx
802.11n/ac HT20: -67dBm@MCS8 1Rx, -90dBm@MCS0 1Rx
802.11n/ac HT40: -64dBm@MCS9 1Rx, -87dBm@MCS0 1Rx
802.11n/ac HT80: -60dBm@MCS9 1Rx, -84dBm@MCS0 1Rx
(Added 3dBm@2Rx in average, ±2 dBm tolerance)
|
|
Attached Antenna
|
Embedded Wall/Ceiling-mount 180° 2.4G 2T2R + 5G 2T2R bands antenna with a reflector plate. Radio Pattern 1/2: 2400-2500MHz Frequency, 9dBi peak gain
Radio Pattern 3/4: 5150-5350MHz: 10dBi peak gain, 5475-5874MHz: 8dBi peak gain VSWR: 2.5:1
Range from 150m ~300m depends on the location, check the manual for detail.
|
|
Transmission Rate
|
802.11a/g: 6, 9, 12, 18, 24, 36, 48 and 54 Mbps
802.11b: 1,2,5.5,11Mbps
802.11n: 6.5 to 300Mbps (Multiple Rates, depends on MCS Index and Ground Interval) 802.11ac: 6.5 to 866Mbps (Multiple Rates, depends on MCS Index and Ground Interval)
|
|
Management
|
|
|
Management
|
Web GUI, Telnet, SNMP, IP Setup, Management VLAN ID, Configuration Backup/Restore, Firmware Upgrade, Reload Default, Ping, SNTP, USB Storage
|
|
WLAN Setup
|
Operation Mode: Wireless AP/Client, WDS-AP/Client
Wireless Setting: Radio on/off, SSID Configuration, Security Settings, Output Power, Data Rate, Frequency/ Channel selection, Traffic Shapping, Maximum Client Number, WMM QoS Link Test: Site Survey, Antenna Alignment Tool, Data Rate Test
|
|
Wire/Wireless Integration
|
Ethernet Port and WLAN Link Fault Pass-Through Spanning Tree Protocol, Link Layer Discovery Protocol
|
|
Router/Gateway
|
Operating Mode: Bridge or Router mode for the Ethernet/Wireless Interface NAT, Hardware-based NAT Routing, DHCP Server/Client
|
|
SNMP
|
Simple Network Management Protocol v1/v2c/v3, SNMP Trap Function-based MIB (Same as other Korenix Wireless AP)
|
|
Status & Log
|
System Information, ARP Table, DHCP Client List, System Event Log
|
|
Controller-based AP
|
Controller-based management by Korenix IWLAN Controller
|
|
Utility/NMS
|
Support Korenix View Utility, Korenix NMS
|
|
Security
|
|
|
Secured Access
|
HTTPS, SSH, IEEE 802.1X, Radius Server
|
|
WLAN Security
|
Multiple SSID(up to 8x SSID), VLAN ID, SSID Broadcast
|
|
Security Encryption
|
WEP 64/128bits, WPA-PSK(TKIP), WPA2-PSK/EAP(TKIP, AES, IEEE 802.1x/Radius)
|
|
Firewall
|
Inbound/Outbound Firewall Setting, DMZ, Port forwarding
|
|
VPN
|
Open VPN, IPSec
|
|
Power Requirement
|
|
|
Power
|
JetWave 4020/4020E: Dual DC 24V input or Passive 24V PoE on GT1, Accepted Input Range:
±15%
JetWave 4020-HV: Dual DC 110V input, Accepted Input Range: ±15% (*Optional selection
by project, check with Korenix Sales.)
|
|
Power Consumption
|
Standby Mode: 4.4W/24V, 5.5W/110V (Power on only) Full Load: Max. 9.6W/24V, 8.8W/110V
Suggest to reserve 15% tolerance power in practical installation.
|
|
Mechanical
|
|
|
Enclosure
|
IP67
Aluminum Body + Plastic (SABIC) Cover
|
|
External Antenna
|
JetWave 4020: N.A. (Protected by cap.) JetWave 4020E: 4x N-Type Sockets
|
|
Vent
|
Vent for heat dispersing
|
|
Mounting
|
Pole-mount, Wall-mount or Ceiling Mount
*Equipped with Mounting kit in shipment
|
|
Dimension
|
236.8mm(H) x 266.8mm(D) x 91.5mm(W)
|
|
Weight
|
4Kg with package
|
|
Environmental
|
|
|
Operating Temperature
|
-40° ~ 70°C
|
|
Operating Humidity
|
5% ~ 95% (operating)
|
|
Storage Temperature
|
-40° ~ 85°C
|
|
Approvals
|
|
|
Certification
|
R&TTE:
CE EN55022/55024
EN 50121-1/EN50121-4:2006 +AC;2008 EN 301 489-1 V1.9.2/-17 V2.2.1(WLAN)
EN 301 893 V1.8.1 (5G 802.11ac WIFI and DFS) EN 300 328 V1.9.1(2.4G WIFI)
EN 62311:2008 (2412~2472MHz, 5180-5240MHz, 5500-5700MHz)
Safety EN60950-1
FCC Part 15 C/E (2.4G/5G) for FCC model
|
|
Warranty
|
3 years
|
